Dymo LP200 Printer User Manual


 
7
Cleaning
Clean the cutter blade regularly: Press and hold down
cutter lever E to expose cutter blade D
, then use a
cotton bud and alcohol to clean both sides of the blade.
Release cutter lever E.
Check and clean print head face D
regularly using a
cotton bud and alcohol ONLY.
Troubleshooting
No display
check that the machine is on
replace weak batteries
check AC adaptor.
No printing or poor text
replace weak batteries
check that the tape cassette is installed correctly
clean the print head
replace the tape cassette.
Tape jammed
1. lift out tape cassette carefully
2. remove/release jammed tape
3. DO NOT cut the ink ribbon turn spool
Cto tighten
4. cut off excess label tape
5. refit/replace the tape cassette.
Poor print quality with white ink
When using a White on Black or a White on Clear
cassette, it may be necessary to use the darkest
contrast setting in order to obtain good print quality.
To change the contrast setting via the keyboard, read
and follow the instructions as described in the
paragraph Print Contrast.
Poor cutter performance
clean the cutter blade regularly, as described above.
No response to print key
!!!!!!!!!!!!!!! in the display indicates a printer jam.
Press any key to return to normal display. Open the
cassette compartment and free the jam.
flashing in the display
indicates discharged batteries. Press any key to return
to normal display. Replace the batteries.
No success?
Call the DYMO customer service hotline telephone
number for your country see the warranty booklet.
PRINT CONTRAST may be adjusted by pressing
+
SYMBOLS
followed by
PRINT
to display the contrast
symbols
.
Use
or to select lighter or darker print.
Press
to confirm the setting. The contrast level will
revert to the mid-setting when the LabelPOINT is
turned off and on again.
Note: This function enables you to adjust the print
quality under extreme temperature conditions.