Filter
Top Products
12
Punching Holes in Non-Adhesive Labels
You can choose to punch one or two holes in non-adhesive labels so
that the labels can be attached using screws, nails, rivets, and metal
or plastic wires or ties. You can also punch a cable tie slot in one or
both ends of the label.
To punch a hole
1. Insert one end of the cut label into the hole punch slot (L).
2. Lift the cutting handle (I) to the vertical position to punch a hole.
To punch a cable tie slot
1. Insert one end of the cut label into the cable tie slot (K) with the
letters facing down. The letters must face down to ensure the
bridge of the slot is on the same side of the label as the
characters.
Make sure to allow enough room for the tie-buckle before
and/or after the letters. A cable tie slot positioned on top of the
characters or a punched hole may cause the tape to jam.
2. Lift the cutting handle (I) to the vertical position to punch the slot.
L
K
I