Filter
Top Products
6
DX-PS06CC
Setting up the shredder
Warning: Crosscut shredders have very sharp exposed blades on the underside. Use care
when mounting the shredder on the wastebasket.
Caution: The shredder should not be plugged in during assembly.
Note: The following illustrations are for information purposes only. Your actual shredder may
look somewhat different than the shredder shown.
To set up the shredder:
1 Position the shredder head over the basket.
2 Place the shredder head on the basket so that it solidly rests on the basket edges.
Note: Always make sure that these two labels are aligned on the same side of the shredder
when you place the shredder head onto the basket. This shredder has a safety interlock
which prevents it from operating unless the shredder head is placed on the basket
correctly.
Using the shredder
Note: Prepare paper to be shredded by removing staples and paper clips from the paper.
Make sure that each batch of paper does not exceed the recommended capacity of six
sheets.
To use the shredder:
Caution:
• Do not overfeed the shredder: Shredding beyond the specified sheet capacity can
result in extensive damage to the shredder. Overfeeding will strain the machine and
quickly wear and break the cutting blades and internal components.
DX-PS06CC_13-0652 MAN_V2_ENG.fm Page 6 Thursday, June 27, 2013 2:04 PM