Filter
Top Products
Console Software
31
Console Software
The input monitor controls are a little complicated. Basically, there is a different
set of input monitor controls for each output bus, but only one set is visible and
changeable at a time. In the example above, the only set of input monitor controls
that is visible and changeable is the one for the output bus called “Analog 1-2". To
see and change a different set of input monitor controls you will need to select a
different output bus (see the “Bus Select” section above).
The level meters do not change when a different output bus is selected. They
always reflect the signal level being received on the inputs. In the example above
you can see that the signal level on the ANALOG Out 1-2 meters is less than that
on the input meters. This is because the ANALOG 1-2 faders have been adjusted to
–19, thereby decreasing the amount of the input signal that is being sent to analog
outputs 1-2. If the Analog 3-4 tab is selected the console would appear as in the
example below.