Filter
Top Products
The PrintSir can be configured as DHCP server to
provide dynamic IP addresses assignment. The DHCP Cfg
page allows you to set:
z The DHCP startup, which determine if the PrintSir
will act as DHCP server. If this item is set to Auto,
the PrintSir will detect if there is any DHCP server
on the network when it boots up. If there is no
DHCP server on the network, then the PrintSir will
configure itself as DHCP server; otherwise it will
disable this function.
z DHCP setup is used to configure TCP/IP
parameters that will be assigned to a DHCP client.
If this item is set to Auto, the PrintSir will
determine all TCP/IP parameters automatically;
otherwise you will configure the following
parameters:
z IP Address: specifies the IP address of PrintSir
itself.
z Starting IP: specifies the starting IP address for
assigning to DHCP clients.
88