Filter
Top Products
DIVA T/A ISDN Modem Reference Guide
◆
Page 46
Multilink PPP Commands
The following table describes the MLPPP configuration commands.
AT%M 1=n
Local Endpoint Discriminator Class
. The value for ‘n’ specifies the Local Endpoint
Discriminator Class. If you specify n=1 (class 1), the Local Endpoint Discriminator
Address (specified with AT%M3=n) must be an even number. For a list of classes, see
“Endpoint Discriminator Class/Address”
on page 48.
AT%M 2=n
Remote Endpoint Discriminator Class
. The value for ‘n’ specifies the Remote
Endpoint Discriminator Class. For a list of classes, see “Endpoint Discriminator
Class/Address” on page 48.
AT%M 3=n
Local Endpoint Discriminator Address
. The value for ‘n’ specifies the Local
Endpoint Discriminator Address. For a description of permitted addresses, see
“Endpoint Discriminator Class/Address”
on page 48.
AT%M 4=n
Remote Endpoint Discriminator Address
. The value for ‘n’ specifies the Remote
Endpoint Discriminator Address. For a description of permitted addresses, see
“Endpoint Discriminator Class/Address”
on page 48.
AT%P5 =n
Bandwidth Allocation Control Protocol (BACP) / Bandwidth on Demand (BOD)
.
This command specifies whether BACP/BOD is enabled or disabled. When enabled,
the DIVA T/A will drop to one B channel (reducing costs) when throughput drops
below 64K. The DIVA T/A first attempts to negotiate BACP; if this is unsuccessful, the
DIVAT/A falls back to BOD.
n=0 Disable (default).
n=1 Enable.
Note: You can use this parameter only if the DIVAT/A has been configured for MLPPP.
AT%P6 =n
Set Initial Billing Interval Timer
. Sets the timer (in seconds) to match the amount of
time your ISDN provider allocates as the first time interval.
Note: If the value is set to 0, the timer is not used. Setting this value to 0, also
effectively sets AT%P7 to 0.
Range: 0 to 65535.
Default: 60 seconds.
AT%P7 =n
Set Billing Interval Timer
. Sets the timer (in seconds) to match the amount of time
your ISDN provider designates as the minimum chargeable unit for all subsequent
billing.
Note: If the value is set to 0, the timer is not used.
Range: 0 to 65535.
Default: 60 seconds.