Filter
Top Products
13
mode. Each slave setting will have a different function for a dynamic lightshow
without a controller.
Auto Program
This function allows the internal programs to run in either stand-alone or master/
salve mode. In “Master” mode the fixture will send DMX data to other fixtures
connect via the DMX chain. In “Alone” mode the fixture will operate as a single
fixture. The program for this mode is selected in the “Select program” section of
the control menu. You can set the number of steps under “Edit program”. You can
edit the individual scenes under “Edit scenes”. With this function, you can run the
individual scenes either automatically, i.e. with the adjusted Step-Time.
Music control
This function is similar to the “Auto Program” described in the previous section with
the exception that this function will advance the built-in program via sound.
Information:
Time information
These functions will detail different time functions associated with the fixture.
Current Time
This function displays the running time of the fixture from the last power on. The
display shows “XXXX”, where “XXXX” represents the number of hours the fixture
has been running. This counter is automatically reset after every power-on.
Total Run Time
This function tracks the total running time of the fixture from the very first start-
up. Where “XXXX ”represents the total number of running hours. This time is
none destructive and will remain in the fixtures memory indefinitely.
Last Run Hours
This function tracks a cycle run time. Use this function to keep track of rental
period, or to note the time from the last service. This setting can be reset at any
time.
“L-Timer Password.”
Lamp Hours. This function tracks the total number of lamp running hours. Where
“XXXX” represents the number of hours the lamp has been running. This
XM485-V1.0-NR