Elite Screens 062310-JA Projector Accessories User Manual


 
2
NOTE:
This equipment has been tested and found to comply with the limit s for a Class B
digital device pursuant to Part 15 of the FCC Guidelines.
The products are designed t o provide reasonable protection against harmful
interference in a residential/commercial installation and end user application and
may radiate radio frequency energy.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. The power outlet should be close to the unit and easily accessible.
2.
Re-orient or relocate the receiving antenna.
3. Increase the separation between the equipment and the receiver.
4. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
5. Consult t he dealer or an experienced radio/TV technician f or additional help.
SCREEN OPERATION
Setup:
Remove
the
controls and wiring
from
the
compartment
on
the
left
side of
the Kestrel
Floor
Electric
Screen
as
shown
in
the
pictures below.
Connect the screen
to
the
power
supply
and
switch the power button on. Now it is
ready for use.
Power:
About the Control System:
1.
5-
12V
Trigger Input:
The built-in 5-
12V
trigger input
for
your
new
Elite
Kestrel
allows
your
screen to synchronize its
rise
and
drop
with
the
projectors
power
cycle.
The
screen
rises
when
the
projector
powers
up and
retracts
when
the
projector
powers
down.
2.
IR
(Infrared)
and
RF
(Radio
Frequency):
The Kestrel Series screen includes both IR and
RF receivers that enable the consumer to use either the IR remote control with direct line of
sight through the screen’s IR receiver window. The RF remote is best used when the screen is
concealed or long distance control is required. The RF technology therefore does not require
line of sight directly to the screen’s IR receiver window.
ON OFF