Filter
Top Products
LPe11002 Hardware Installation Manual Page 4
3. Remove the computer case.
4. Remove the blank panel from an empty PCIe bus slot. Follow steps 5
–8 to change the bracket if
they are different sizes. Otherwise, skip to step 9.
5. Remove the mounting bracket screws from the top of the HBA.
Figure 2: Removing the Bracket
6. Remove the bracket and store it for future use.
7. Align the new mounting bracket tabs with the holes in the HBA.
8. Replace the screws that attach the HBA to the bracket.
9. Insert the HBA into the empty x4 or higher PCIe bus slot. Press firmly until the adapter is seated.
10. Secure the HBA's mounting bracket to the case with the panel screw or clip.
11. Replace the computer case and tighten case screws.
The HBA is now installed in the PC and is ready for media attachment.
Note: For best I/O performance, place the adapter into an empty PCIe x4 or higher slot.
PCIe slots are shorter than standard PCI 64-bit slots. Do not attempt to plug the
adapter into a standard PCI slot.
Note: The HBA comes with a standard PCI bracket installed. A low-profile bracket is
included in the box with the HBA. The low-profile mounting bracket is shorter than
the standard bracket; approximately 3.11 in. (7.9 cm) compared to 4.75 in. (12.06 cm)
long.
Note: Be careful not to push the bracket past the transceiver housing's grounding tabs.
Make sure the light emitting diodes (LEDs) are properly aligned with the holes
in the bracket.