Filter
Top Products
8
INSTALLATION
Hardware Installation
To connect this drive to your PC, you will need one SATA port for the
SATA drive.
1. With the power to your PC disconnected, remove the PC’s top cover.
2. Insert the drive into one of the free 5¼" bays available for disk drives
and secure it with screws to your PC.
3. Connect the 7-pin Signal & 15-pin Power Segment Key cable from
your hard disk to the back of the DVD Writer drive.
4. If you have a sound card that can be connected to this drive, you can
also connect Audio-Out of the drive to Audio-In of the sound card with
a 4-pin audio cable.
Please make sure to connect Pin 1 from Audio-Out of the
Writer to Pin 1 from Audio-In of the sound card.
5. Reinstall the casing on your PC, and reconnect the power supply.