Support User Manuals

Enterasys Networks 4H4282-49 Network Hardware User Manual

Open as PDF

of 90

Completing the Installation

Matrix DFE-Gold Series Modules Hardware Installation Guide 3-29

Logging in with an Administratively-Configured User Account

Ifthedevice’sdefaultuseraccountsettingshavebeenchanged,proceedasfollows:

1. Attheloginprompt,enteryouradministratively‐assignedusernameandpress

ENTER.

2. AtthePasswordprompt,enteryourpasswordandpressENTER.

ThenoticeofauthorizationandtheMatrixpromptdisplaysasshownbackinFigure 3‐15.

The

DFE‐Gold moduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP

addressandconfiguringTelnetsettingsforremoteaccesstoDFEmanagement,referto

Chapter3intheEnterasysMatrixDFE‐GoldSeriesConfigurationGuide.TheCLIcommands

enableyoutoinitiallysetupandperformmore

involvedmanagementconfigurations.

TheEnterasysMatrixDFE‐GoldSeriesConfigurationGuideisavailableonlineat:

http://www.enterasys.com/support/manuals

Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed

in“GettingHelp”onpage xviii.

Note: Users with Read-Write (rw) and Read-Only access can use the set password

command to change their own passwords. Administrators with Super User (su) access

can use the set system login command to create and change user accounts, and the set

password command to change any local account password. For information on the set

password and set system login commands, refer to Chapter 3 in the Enterasys Matrix

DFE-Gold Series Configuration Guide

.

previous next