Support User Manuals

Enterasys Networks C2RPS-POE Power Supply User Manual

Open as PDF

of 34

Installing the C2RPS-POE on a Flat Surface

SecureStack C2 Installation Guide 2-3

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 2‐1andproceedasfollows:

1. PlacetheC2RPS‐POEonitsbackonasturdyflatsurfacetogainaccesstothebottom

ofthechassis.

2. Removethefourrubberfeetfromtheirplasticbagintheshippingbox.

3. Locatethefourmarkedlocations

onthebottomfourcornersoftheC2RPS‐POE.

Figure 2-1 C2RPS-POEBottom, Rubber Feet Placement

4. Removetheprotectivestripfromthebackofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeet.

5. Afterinstallingtherubberfeet,returnthe

C2RPS‐POEtoitsuprightposition.

6. ToinstalltheC2RPS‐POEonaflatsurface,proceedto“InstallingtheC2RPS‐POEona

FlatSurface”onpage 2‐2.Forarackmountinstallation,proceedto“RackMounting

theC2RPS‐POE”onpage 2‐5.

1 Bottom of C2RPS-POE 3 Rubber feet with adhesive backing (4)

2 Locations to install the rubber feet (4 locations)

À

Á

ÂÂ

ÂÂ

previous next