Filter
Top Products
CUSTOMER RELEASE NOTES
1/21/09 P/N: 9038177-27 Subject to Change Without Notice Page: 23 of 28
F0615-O
Firmware Release 6.0.7.2:
If a location policy (ACL) is added to an SSID that is using Web Authentication, the preconfigured portal ACL
will be overwritten and fail to load the logon page. It is strongly recommended not to adjust settings on the
preconfigured web portal ACL.
Disabling the dot1x authcontrol function may cause authentication issues. This is a global setting, reaching
many portions of the authentication code. It should remain enabled at all times unless specifically directed to
disable it. This does NOT turn on dot1x on any of the SSIDs.
ACL names can contain special characters (/,\,-,_), but they cannot contain spaces. ACL names must also
begin with a letter and not a number.
Due to a hardware limitation for the RBT3K, the lowest achievable power setting is 10 dB (lowest setting).
The RBT-8400 4 front panel ports are 1Gb ports copper or fiber (default) only.
The unmanaged RBT3K (fat-AP) may encounter conversion upgrade issues to managed mode (thin-AP)
across a routed network.
A single "*" used for User Glob does not work when using TLS.
WEP keys cannot be entered in ASCII format. HEX format is currently the only supported input.
The RBT-1002 does not support the automatic generation of RSA values (fingerprints). The dynamic creation of
the fingerprint occurs on Access Points that are ‗fat-to-thin‘ conversion types.
For the most up-to-date information concerning known issues, go to the Global Knowledgebase section at
http://www.enterasys.com/support/. To report an issue not listed in this document or in the Global
Knowledgebase, contact our Technical Support Staff.
Tech Tip for Choosing External Antenna Types for the RBT-1602 (AP ID: AP1602 & AP1602C) and
TRPZ-MP-422 (AP ID: MP422 & MP422A)
When you select an antenna type for the RBT-1602 and TRPZ-MP-422, the menu choices that are displayed are
listed in the left-hand column in the table below. Use the antenna part numbers listed in the right-hand column to
identify the correct menu choice.
RASM/RBT Antenna Choice:
Enterasys Antenna Part Number:
ANT1060
RBTES-BG-S1060
ANT1120
RBTES-BG-S07120
ANT1180
RBTES-BG-S06180
ANT5060
RBTES-AW-S1460
ANT5120
RBTES-AW-S12120
ANT5180
RBTES-AW-S10180
Tech Tip for the Channel availability for the new DFS2 model Access Points
DFS2 compliant Access Points support fewer channels than non-DFS2 compliant Access points.
Channel availability is based on the AP ID of the installed Access Point. An Access Point with the character of ―A ―
or ―C‖ on AP ID label denotes a DFS2 compliant device. The country of operation and regulatory domain
determine exactly what channels are available for use.
IETF STANDARDS PROTOCOL SUPPORT:
Groups
Supported
RFC No. / Title
Description
Security and AAA
RFC 2246
Transport Layer Security (TLS)
RFC 2284
EAP
RFC 2315
PKCS #7: Cryptographic Message Syntax
Version 1.5