Filter
Top Products
EN7220
8
INSTALLATION INSTRUCTIONS (Cont)
Supplied with units intended for connection to power outlet of personal
computer: Please use a cord set consisting of a minimum No. 18 AWG, type
SJT or SVT three conductors flexible cord. One end terminates with a
grounding type attachment plug, rated 10A, 250V, CEE-22 male configuration.
The other end terminates with a molded-on type connector body, rated 10A,
250V, having standard CEE-22
female configuration.
Please note that power supply cord needs to use VDE 0602, 0625, 0821
approval power cord in European counties.
Connecting The Cables
Figure 2 Connecting Cables
1. AC Power Cord 2. 15-pin D-SUB Cable
Turn off your computer before performing the procedure below.
1. Connect the female end of the AC power cord to the AC-in port on the
back of the monitor. Connect the other end to a nearby AC-outlet.
3. Connect one end of the 15-pin D-Sub cable to the back of the monitor and
connect the other end to the computer’s D-Sub port.
4. Turn on your monitor and computer. If you monitor diplays an image,
installation is complete. If not, refer to the FAQ (frequently asked questions)
section for troubleshooting.