Filter
Top Products
Setting Up the Printer 17
1. Unpack the printer as explained in the printer’s Unpacking
Sheet, then follow the instructions in the printer’s Setup Guide
to carry out the following procedures.
❏ Installing the face-up tray
❏ Installing the toner cartridges
❏ Installing the photoconductor unit
2. Make sure that the printer is not plugged in.
3. Remove the two screws securing the shield plate on the rear
of the printer; then remove the plate.
Note:
❏ You will need the screws to secure the printer interface board
later in this procedure.
❏ Keep the shield plate in a safe place. You will need to reattach it
if you remove the interface board later.