Epson C70 Printer Accessories User Manual


 
INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70 3
Put this system on the right side of printer, tidy up ink flow tubes, pull out an air
balance plug and replace it with an air filter with the bigger side downwards.
3. Move out cartridge holder
Insert screwdriver like, screw screwdriver like until take cartridge cover off.
4. Install the system ink cartridges
Take cartridges out. Install CISS cartridges according to printer indication and
press cartridge down to the place.
5. Attach tubes
Tear sponge seal off. Tidy up ink tube. Stick rack onto the printer cover like.
Make sure that tube and rack will not fall off while printing. Do not twist ink tube.
6. Check wire length
Move cartridge holder to left side, then to right side, check if the tube is too long
or too short. Move cartridge holder to right side, check if ink tube will fall down during
movement, if fall down, then the holder will be blocked during printing. Generally,
before shipment, we have adjusted the tube to the right size, please double check before
printing.
7. Adjust wire length
If step 6 is ok, then there is no need to go through this step.
If the tube length is too short then lengthen it, if too long then shorten. If the tube falls
down, you need adjust the angle of sticker to prevent falling.
8. Take place meter off
Tidy up ink tube. Tear seal off, attach fixation like. Press ink tube while closing
printer cover to avoid deforming of ink tube.
9. Prepare for printing
Plug power wire on (3-9-1), turn printer on. Check whether printer and ink tube
can run normally. Close printer cover and check whether it is strange noise while
printing.
Pic. 3-9-1
10. Check printer nozzle