Filter
Top Products
SmartPanel Projector Driver Application Note
Epson EMP-7800
© 2004 SP Controls Inc. 601 Minnesota Suite 115, San Francisco, CA 94107
help@spcontrols.com
Hidden functions are accessed by pressing the indicated key while the holding the On key down.
Hidden functions names are based on the Epson remote and controls on top of the projector. Adjust,
Enter and ESC controls navigate through onscreen menus. A/V Mute is a toggling Audio and Video mute.
The hidden functions available for the Epson with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
ESC
BRIGHT +
BRIGHT –
E-ZOOM +
E-ZOOM –
SYNC +
SYNC –
TRACKING +
TRACKING –
A/V MUTE
HELP
RESIZE
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the
rear of the SmartPanel. The Configuration
Utility can be used to customize these settings
your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method RS-232 Polling (see note 1)
Control Wiring Option RS-232 Only (see note 2)
All control for the Epson with this Driver is via RS-232. However, SP Controls strongly recommends
wiring the IR emitter. See Section III. Projector Firmware Note below for more information.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the SmartPanel Configuration and Installation
Manual.
Lockout Timer 42 seconds (see note 3)
Inactivity Shutdown Disabled
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A
1B
3A
3B
2A
2B
4A
4B
6A
6B
5A
5B
7A
7B
SELECTION
(EXT. SWITCHER CTRL)
4321
500mA MAX. CURRENT