Filter
Top Products
Others menu
Submenu Function
SNMP
Set to On to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is Off.
Trap IP Address
1/Trap IP Ad
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
Priority Gateway
(Except for EB-S29/
EB-S27)
You can set the priority gateway to a Wired LAN or Wireless
LAN.
AMX Device Dis
covery
When the projector is connected to a network, set this to On to
allow the projector to be detected by
AMX Device Discovery
g
.
Set this to Off if you are not connected to an environment
controlled with a controller from AMX or AMX Device
Discovery.
Submenu Function
Crestron Room
View
(Except for EB-S29/
EB-S27)
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off.
s "About Crestron RoomView
®
(Except for EB-S29/EB-S27)"
p.93
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor plugin)
Control4 SDDP
Set this to On to allow device information to be acquired using
Control4
®
Simple Device Discovery Protocol (SDDP)
g
.
Bonjour
Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
s http://www.apple.com/
Message Broad
casting
You can switch the EPSON Message Broadcasting function to
enable or disable.
List of Functions
116