Epson EB-W28 Projector User Manual


 
c
While holding down the [Menu] button on the remote control or
the control panel, connect the power cord to the projector.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power: Blue - On / Status: Blue - On / Lamp: Orange - On / Temp: Orange - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
Do not disconnect the power cord from the projector while the
settings are being written. If the power cord is disconnected, the
projector may not start correctly.
Do not disconnect the USB flash drive from the projector while the
settings are being written. If the USB flash drive is disconnected, the
projector may not start correctly.
d
When writing completes normally, the projector enters standby
status.
Power: Blue - On
When the projector is in standby status, remove the USB flash
drive.
Setup by Connecting the Computer and Projector
with a USB Cable
a
The following operating systems support the batch setup function.
Windows Vista or later
Mac OS X 10.5.3 or later
Performing Batch Setup for Multiple Projectors
99