Filter
Top Products
35
Configuration Menu Functions
Configuration Menu
(Setting is not possible when "Color Mode" is set to "x.v. Color.")
This reduces flickering of images.
Three modes are available. Select the mode to suit your liking.
Set "Off" when the image source, such as DVD, contains little electrical interference.
This reduces the noise which can be generated around the edges of images when projecting MPEG
images. Three modes are available. Select your preferred mode.
Set to "ON" to reduce block noise which can occur when projecting MPEG images which have been
compressed at a low bit rate.
(This can be set when NTSC
signals are being input from the [Video] / [S-Video] input ports, or when
component video signals are being input from the [Component] input port.)
If using products designed for destinations such as South Korea that have different black level (setup
level) settings, use this function to obtain correct images. Check the specifications of the connected
equipment when changing this setting.
(
Setting is only possible when Color Mode is "Natural", "Cinema Night", "HD", or "Silver Screen", and
composite video, S-video, or component video signals are being input.)
If bright white areas of images such as clouds and T-shirts on the beach in summer appear uneven and
overexposed, set to "On". When set to "On", the "HDMI Video Range" setting will be ignored.
(Setting is not possible when composite video
, S-Video , or computer signals are being input.)
This changes the display area (the part of projected images).
• 100% - 92% :When 100% is set, the top and bottom of the image is sometimes affected by electrical
interference depending on the image signal. In such cases, try to adjust the display
position ("Position"). p.34
• Auto :Displayed when the signals from
[HDMI1] / [HDMI2]
input port are being input. Signals
are automatically projected at 100% or 92% size depending on the input signals. (Not
displayed when the equipment's DVI port is connected to the projector's
[HDMI1] /
[HDMI2]
input port.)
(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v. Color.")
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example, set
the video range of the projector to suit the video range setting of the DVD player. The setting at the DVD
player can be either Normal or Expand.
(This setting can be made only when a 1080p/24Hz signal is being input to the [Component] or
[HDMI1], [HDMI2] input terminals.)
For a 1080p/24Hz input signal, you can select between 2-2 pull-down projection or 2-3 pull-down
projection. Selecting "On" sets the 2-2 pull-down.
Displayed for input sources other than computer image
Advanced
Noise Reduction
*1
Mosquito NR (EH-TW5000 only)
Block NR (EH-TW5000 only)
Setup Level
*1
EPSON Super White
*1
Output Scaling
*1
HDMI Video Range
*1
2-2 Pull-down (EH-TW3800 only)
*1 The setting values are stored separately for each image source and signal type.