Filter
Top Products
INSTALLATION MANUAL
10
Locking Grid Plate to Receiver Tray
1. After the Receiver Tray (E) has been attached to the ceiling and the projector has been attached
to the Grid Plate (F), slide the Grid Plate (F) into the Receiver Tray (E).
Before completely closing the mount, route the cables that are running down the 1-1/2” Pipe (A)
and out the center of the Receiver Tray (E). (See gure 6)
Slide the Grid Plate (F) in while guiding the cables into a slot located in the back of the Grid Plate
(F). (See gure 7)
2. Put the Screw Lock (I) into the Grid Plate (F) and turn clockwise until it is snug.
WARNING: DO NOT OVER TIGHTEN THE LOCK.
CABLE SLOT
gure 6
gure 7