INSTALLATION MANUAL
7
Mounting Projector to Grid Plate
Soft Cloth or
Packaging Material
1. Turn the projector (P) upside down and place it at on a soft cloth or packaging material. Remove
or adjust the feet to be as ush as possible to the projector bottom.
2. Place the Grid Plate (F) on the bottom of the projector and line it up so the mounting inserts of
the projector (P) can be seen through the holes of the Grid Plate (F). (NOTE: see pages 8-9 for which
mounting holes to use for your model projector)
3. Select the screws (G) for your projector (see pages 8-9 for proper hardware to use for your model
projector)
4. Attach the Grid Plate (F) to the projector using these screws (G) and washers (H). Turn until snug.
Do not over tighten.
NOTE: The 400W need 3/8” Spacers
(J) to level the Grid Plate (F). Place the
Spacers (J) over the mounting inserts
and then place the Grid Plate (F) on
top of the Spacers (J) lining up the
proper holes of the Grid Plate (F) with
the projector’s (P) mounting inserts.