Filter
Top Products
31
Configuration Menu Functions
Configuration Menu
"Settings" menu
This sets automatic adjustment to on or off in order to set whether the projector automatically adjusts
images to their optimum condition when the input signal is changed. The three automatically adjusted
items are "Tracking
", "Position" and "Sync ."
All the adjustment values on the "Image" menu, except "Aspect
", are returned to their default values.
(If the aspect mode is set to "Wide", keystone correction cannot be set.)
This is used to correct keystone distortion in images. The same correction can be carried out using the
projector's control panel. p.17
When the main power switch is turned on, you can set for projection to start (On) / not start (Off) without
pressing or .
When set to "On" with the power left on, be aware that sudden surges of electricity that may occur when
the power comes back on after a power outage may cause the projector to turn on.
The projector is equipped with a power-saving function that causes the power to turn off automatically
and the projector to switch to standby if no signal is input to the projector for a continuous length of time.
The length of time before the power-saving function operates can be selected from four available settings.
If "Off" is selected, the power-saving function will not operate.
If you press while the projector is in standby mode, projection will start again.
This turns the trigger function on and off to determine whether the projector's power on/off status and
problems with projector operation are communicated to an external device.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
This locks the power on function of the button on the projector's control panel, so that a child cannot
accidentally turn the projector's power on and look into the projector's lens. When the lock is applied, the
power will only turn on if is pressed down for about 3 seconds. can be used to turn off the power,
and the remote control will continue to operate as normal.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
When the "Direct Power On" is set to "On", be aware that projection starts immediately as main power
switch is turned on.
If this is set to "On", you can't operate the projector's control panel buttons and a icon appears on the
screen when a button is pressed. To cancel, press and hold on the projector's control panel for about
seven seconds or more.
If you change the setting, the new setting will take effect after exiting the configuration menu.
Auto Setup
Reset
Keystone
Operation
Direct Power On
Sleep Mode
Trigger Out
Child Lock
Operation Lock