Filter
Top Products
9
Changing Settings Through the Default Setting Mode
The LQ-570e includes a Default Setting mode which lets you set
the functions controlled by DIP switch settings on the LQ-570+,
plus a number of additional features. The table below summarizes
the differences. (Default settings are in bold.) To enter the Default
Setting mode, make sure the printer is off and paper is loaded.
Then hold down the Font button and press the power switch to
turn on the printer. Instructions are printed which you can follow
to change any settings. When you are finished, turn off the printer
to exit the Default Setting mode.
Note:
You can also change the default settings using the EPSON Remote!
utility. See Chapter 5 in your
LQ-570e User’s Guide
.
Setting LQ-570+ LQ-570e (Default
Setting mode)
Page length for
continuous paper
(tractor)
DIP switches 2-1 and 2-2
select 8.5, 11, 11.7, and 12
inches
Length in inches: 3, 3.5, 4,
5.5, 6, 7, 8, 8.5,
11
, 70/6, 12,
14, 17
Skip over
perforation
DIP switch 1-8 (On, Off) On,
Off
Auto tear-off DIP switch 2-3 (On, Off) On,
Off
Auto line feed DIP switch 2-4 (On, Off) On,
Off
Print direction DIP switch 1-5 (Bi-D, Uni-D) Auto,
Bi-D
, Uni-D
Software (printer
mode)
DIP switch 1-6
(ESC/P2, IBM emulation)
ESC/P 2
, IBM
®
2390 Plus
0 slash not available On: ,
Off: 0
High speed draft not available
On
, Off
I/F mode not available
Auto
, Parallel, Optional
Auto I/F wait time not available
10 seconds
, 30 seconds
Parallel I/F
bidirectional mode
not available
On
, Off
Packet mode (IEEE
1284.4 protocol)
not available
Auto
, Off
0