Filter
Top Products
2. Load a fanned stack of paper (up to 50 sheets), aligning the
right edge of the paper with the right paper guide. Be sure to
load the paper with the printable side up. Adjust the left paper
guide and center support to fit the paper, and then push back
the paper set levers to lock the paper in place.
3. Before printing, make sure the paper release lever is set to the
single-sheet position. Also set the paper thickness lever to the
correct position for the paper loaded in the cut-sheet feeder, as
described on page 3-6.
4. In your printer driver software, select your paper size from
the Paper Size list, and select
Sheet Feeder Bin-2
from the
Paper Source list. (If you are printing from a DOS application,
select the bin number using the
Tear Off/Bin
button on the
control panel.)
The cut-sheet feeder loads paper when you send data to the
printer. You can also load paper by pressing the
Load/Eject
button.
A66
L
Adonis Rev.E
A5 size Chapter 5
97/04/07 pass 0
5-12
Using Printer Options