Filter
Top Products
Auto carriage return
When the auto carriage return feature is on, each line feed (LF)
code or ESC J (n/216-inch line feed) code is accompanied by a
carriage return (CR) code and the printer moves the next print
position to the left margin. When this feature is off, you must send
the CR code after the line feed code to move the print position to
the left margin. This feature is available in IBM emulation mode
only.
0 slash
The zero character has a slash (Ø) when this setting is on; it has no
slash (0) when the setting is off. This allows you to easily
distinguish between an uppercase “O” character and a zero.
Buzzer (Beep)
The printer beeps when some errors occur. See “Troubleshooting”
in Chapter 6 for more information.
Roll paper
When you turn on this mode, roll paper is not recognized as
single-sheet paper even if the paper release lever is set to the
single-sheet position. This means that the paper is not ejected and
advanced forward to the next page with the
LF/FF
button.
3-12
Using
the Printer