Filter
Top Products
Setting Up the Scanner
Follow the steps below to set up the scanner and connect it to
the SCSI port on your Macintosh or to another SCSI device.
The SCSI cable included with the scanner has a 25-pin
connector on one end and a dual 25-/50-pin connector on the
other.
1. Take the scanner out of its box and place it on a flat, stable
surface with the rear panel facing you.
2. Remove the tape securing the scanner cover and pull out
any packing material from underneath the cover.
3. Turn off your Macintosh, scanner, and any other peripheral
devices. The scanner is turned off when the
O
side of the
power switch on the rear panel is pressed down.
c
Caution:
Be sure that your Macintosh, scanner, and any other
peripheral devices are turned off before you plug in any
cables.
4. The scanner’s default SCSI ID setting is 2. If you need to
change the scanner to another SCSI ID, press the plus or
minus button next to the SCSI port until you see the desired
number in the display. (Be sure you do not select a number
assigned to another device.)
25-pin connector to the scanner
50-pin connector for an additional device
3
Getting Started