COMMAND 1: BUFFER SIZE
Selects logical default buffer size
VALUE DESCRIPTION
1
960 characters
*2
1920 characters
3
2560 characters
4
3440 characters
5
3564 characters
NOTES: This command, along with the ‘Z99,0’ command, changes the logical
buffer size selection in the non-volatile memory of the interface.
The
logical buffer size is only reported to the host the next time the unit is
powered up.
The physical buffer size is permanently set at 4K.
EXAMPLE: &%Z1,3 Sets logical buffer size to 2560 characters.
COMMAND 2: LINES PER INCH
Selects default LPI.
VALUE DESCRlPTlON
3 3
LPI
4
4
LPI
*6 6
LPI
8
8
LPI
NOTES: This default emulates the front panel selection on an IBM printer.
The IBM host can control the LPI unless Command 36 is used to
select override of host LPI commands.
EXAMPLE: &%Z2,8
Sets the printer to 8 LPI default