Filter
Top Products
57
Sawgrass Technologies, Inc. ~ ArTainium
®
/ChromaBlast
®
DualJet™ Hybrid System 4880
Tips for Successful Sublimation
POLYESTER FABRIC
Maintain appropriate heat press times
• Shortened pressing times will result in good surface color but the sublimation
dyes will not completely penetrate the polyester fibers. This leaves the dyes
more susceptible to wash out.
• Longer pressing times will cause the dye molecules to penetrate deeper into
the fiber, creating a washed out look. For guidelines on transfer times, see the
section entitled Heat Transfer Instructions.
Maintain appropriate heat press temperatures and pressure
• The correct temperature setting is vital for achieving desired results. Higher
temperatures can damage the polyester fibers to the point that they cannot
properly “hold” the dyes. For guidelines on transfer temperatures, see the
section entitled Heat Transfer Instructions.
• Too much pressure on the heat press may cause the dyes to penetrate too
deeply into the fabric causing a washed out look. For guidelines on transfer
pressure see the section entitled Heat Transfer Instructions.
METAL
To obtain the best results when printing onto metal, place the transfer between the metal
and an absorbent cloth or fresh, non-textured paper towel. This will absorb any dyes that
pass back through the paper and any moisture released during the transfer process. If
you have problems with inconsistently filled areas, this may alleviate the problem.
CERAMIC TILES & MUGS
When transferring onto ceramic tiles and mugs, immediately peel the paper off of the
ceramic after removing it from the heat press. Once the paper has been removed, cool
the ceramic by submerging it in cool water, or run water over it from a faucet. If paper
residue remains on the surface of the ceramic, clean with citrus cleaner. If you experience
a significant paper-sticking problem, call your SubliJet reseller for assistance.
UNISUB
• Prepare the Substrate by peeling the transparent protective film off the
surface of the substrate (if applicable) and be sure you are working with a
clean, lint-free surface. To aid in the film removal process, touch laminated
edge of blank product to corner of heated platen on your heat press for about
5 seconds. Plastic will shrink, allowing you to peel away more easily and
reduce chipping the coating.