Filter
Top Products
1
IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturers instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
ECO-FLO CONTINUOUS INK SYSTEM PermaJet
Assembly Instructions for
:R1400
Ink System
It is very important you read these instructions carefully before you begin!
We will take you through the following steps:
1 Preparing your Injector
2 Setting up of the Inks in the bottle tray
3 Installation of the modified injector to your printer
4 Fitting of the Tube Supports System
5 Producing your first print.
Only start work on the installation once you have read the
instructions fully!
What you will need to Install the Eco-Flo R1400
* Complete Eco-Flo R1400 Kit
* Sharp Blade (Stanley Knife type) & Scissors
* Measuring Tape or Ruler
* Marking Pen or Pencil
* Paper Towels
Please read carefully before you continue and
refer to the components diagram over the
page
What is included in your Eco-Flo R1400 Kit
* Injector Set with tubes attached
* Set 6 Inks & empty 100ml bottles
* 6 Bottle Caps & clear piping tubes
* Tube Support Bracket with Self Adhesive
Pads fitted
* Bottle Holder Tray
* Special Injector Lid & 2 Chip Blocks
* 1x Grey/White Tube Clip with adhesive pad
* Installation Instructions and Profiles CD
* 10ml Syringe & wing adaptor
* Pair of latex gloves
* 6 Tube Clamps
* Foam Strip
Epson R1400 Eco-Flo Shown
Epson R1400
Part No. APJ29421
EPSON PRINTER