Filter
Top Products
12
Step 11 Install Injectors
Please place the set of 6 injectors in the printer carriage that is now parked in the centre of the printer.
Carefully align them, and when you are happy the injectors are in position. PLEASE BE CAREFUL NOT TO PUSH
TOO HARD, AS THIS WILL CAUSE DAMAGE TO THE INJECTOR & PRINTER HEAD. Push the injectors home
until you feel a positive seated position, see Fig.28 below. When all are in, they should look like Fig.29 below.
Step 12 Fixing the Special Printer Lid
Attach the special printer lid that has been supplied making sure that none of the tubing catches or squashes
between the lid and housing, as this will stop any ink flowing into the printer heads. At this stage you MUST align the
tubes in the correct manner as illustrated in Fig.30. Align & position the special lid as indicated in Fig.31.
Picture shows injectors fully installed in a
R1400
Fig.28 Fig.29
Fig.30
Fig.31