Filter
Top Products
16
When you have carefully installed and aligned the tube clip in its correct location, press firmly ensuring that the tube
clip is clicked and stuck down to the printer body, as illustrated in Fig.42 below.
Step 16 Installing the Foam Strip
The purpose of the Foam Strip is to ensure that the tubing on the Eco-Flo travels under the printer body correctly, as
well as to cushion the tubes from hitting the printer casing when in motion.
Move the head manually across to the left Peel back the yellow sticky tape ready for installation
and bend back the Foam Strip as illustrated above. on the printer body.
Fig.43 Fig.44
Fig.42
IMPORTANT!
Please note from the diagram on
the left, the positioning of the
Foam Strip is crucial in that only
one tube should be visible from
the above angle. Please follow the
steps over the page.