Filter
Top Products
2008-8-14 13:38 PM
Fig 5-1 Fig 5-2 Fig 5-3
6. Attention:
1. After installing the CI System ,do not remove the cartridges unless it is necessary .If cartridges are removed,
Immediately place cartridges upside down with ink exit holes facing up to avoid leaking .If cartridges are
removed for more than an hour, please cover ink exit holes with tape.
2. When you are printing do not move the ink tank up or down. Keep it stable and at the same level as the printer.
3. Store at 15-35 degrees Celsius.
4. The ink and cartridge flow have been designed and tested to function as a system. We recommend you use the
specially designed ink Low Foam Ink in the CIS for optimal results.
7. Caution:
1. Do not ingest ink and keep out of reach of children
2. Do not leave under sunlight or in extreme weather conditions
3. Do not drop ink tank or handle roughly
To reset the cartridges follow step 8
Fig 8-1
8. When you get the “Replace Cartridge “ message follow these steps.
a. Click on the “How to” button.
b. You will get a screen that tells you to use Epson ink cartridges, click on the “Next” button.
c. The 2nd screen tells you to remove cartridges from the package, click on the “Next” button.
d. The 3
rd
screen lets you know it’s going to move the printheads to replacement position, click on the “OK” button.
e. The 4
th
screen tells you to remove cartridges, click on the “Next” button.
f. The 5
th
screen tells you to install cartridges, when you get this screen the first thing you need to do is push the Reset
button that is on top of the cartridges ( fig. 8-1). Push this button once and then click on the “OK” button.
g. the next screen should show you that the ink is charging, when it is done charging click on the “finish” button.
Fig 8-1