Filter
Top Products
DIP Switch and Paper Near End Settings A-5
Notes:
•
Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are
recognized only when printer power is turned on or when the printer is reset
using the interface. If the DIP switch setting is changed after printer power is
turned on, the change does not take effect until the printer is turned on again
or is reset.
•
If you turn on DIP switch 2-8 while the printer is turned on, the printer may be
reset, depending on the signal state. Do not change DIP switches while the
printer power is on.
•
If the print density is set to level 3 or 4, the printing will be at low speed.
•
In a low power consumption, printing is fixed to 70 mm/sec.