ETA Systems eta-ecm2063 Surge Protector User Manual


  Open as PDF
of 16
 
– 8 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
ETA-ECM2063
AC Power Distribution Sequencer
WIRING THE AC MAINS
Belowarefourconfigurationsforloaddistribution.AfterfollowingthewiringdiagramplacethelabeloftheInternalWiringConfiguration
on the panel box. Note: All electrical wiring must be done by a certified electrician. Follow the steps below for wiring the AC mains.
Accessing the Internal Wiring
1. Locate the Control Input Panel.
2. Remove the four screws. (See diagram below)
3. RemovetheControlInputPanel.Note:Aribboncableisattached.Carefullylaypanelasideleavingthecableattached.
Do not pull on cable or damage may occur.
4. Select the load configuration from the wiring diagram that applies on the following pages.
5. Carefully place the input panel back onto the raceway paying close attention to the ribbon cable to ensure that it does not
become twisted or pinched between the panel and the chassis.
6. Secure the Control Input Panel
7. Select the proper Internal Wiring Label and place it on the front panel.
36.84
3.26 5.25
2.59
 previous next