Filter
Top Products
70064072_V_2_2.DOC
21/40
Occupation of the DIP-switches:
Device 1 - channel 1
On
Off
Starting address
Device number
& channels
Off
Device 2 - channel 2
On
Off
Device 3 - channel 3
On
Off
Device 4 - channel 4
On
Off
Device 5 - channel 5
On
Off
12
4
8
16
32
64
128
256
DIP-switch no.
12
3
4
5
6
7
8
9
Setting the DMX-
starting address:
Device 1 - channels 1-4
On
Off
DMX-starting
address
Projector number
& channels
Off
Device 2 - channels 5-8
On
Off
Device 3 - channels 9-12
On
Off
Device 4 - channels 13-16
On
Off
Device 5 - channels 17-20
On
Off
12
4
8
16
32
64
128
256
DIP-switch no.
12
3
4
5
6
7
8
9
Setting the DMX-
starting address:
This device can be defined as a 4-channel dimmer pack (normal DMX) or as with one address for all 4
channels (DMX parallel).
Please adjust your selection via DIP-switch no. 10.
DIP-switch 1: one address
DIP-switch 0: 4 channels
FUNCTION
1
any one of DIP switch 1-9 is on, DMX parallel
All of DIP switch 1-9 is off, auto parallel
any one of DIP switch 1-9 is on ,DMX
All of DIP switch 1-9 is off , Auto
23456789 10
1
0
1
256
2
4
8
16
32
64
128
Function
DMX ADDRESS
6. OPERATION
After you connected the device to the mains and switched the circuit breaker, the EDX-4 is ready for use.
You can control the desired channel via you lighting controller. When a DMX-controller and an analog
controller is connected, the device reacts to the stronger signal.
7. CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!