EVGA H55V Computer Hardware User Manual


 
Installing the CPU Fan
There are many different fan types that can be used with this
motherboard. Follow the instruction that came with you fan
assembly. Be sure that the fan orientation is correct for your
chassis type and your fan assembly.
Installing System Memory (DIMMs)
Your new motherboard has four 240-pin slots for DDR3 memory. These slots support 256 MB,
512 MB, 1GB, 2GB, and 4GB DDR3 technologies. There must be at least one memory bank
populated to ensure normal operation. Use the following the recommendations for installing
memory.
One DIMM: If using 1 DIMM (Single Channel), install into: DIMM slot 1.
Two DIMMs: If using 2 DIMMs (Dual Channel), install into: DIMM slots 1 and 3.
Four DIMMS: If using 4 DIMMs (Dual Channel), install into: DIMM slots 2, 1, 4, and 3.
Use the following procedure to install memory DIMMs. Note that there is only one gap near the
center of the DIMM slot. This slot matches the slot on the memory DIMM to ensure the
component is installed properly.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into the DIMM
slot. The plastic clips at both sides of the DIMM slot automatically lock the DIMM into the
connector.
Installing the Motherboard
The sequence of installing the motherboard into a system case depends on the chassis you are
using and if you are replacing an existing motherboard or working with an empty system case.
Determine if it would be easier to make all the connections prior to this step or to secure the
motherboard and then make all the connections. It is normally easier to secure the motherboard
first.
DIMM Slot 2 (XMM2)
DIMM Slot 1 (XMM1)
DIMM Slot 4 (XMM4)
DIMM Slot 3 (XMM3)