Filter
Top Products
Operation and Controls
The DermaTemp infrared thermographic scanner models 1001, 1001
LN, LT and RS are all identical in performance and specifications. All
are maximized for ease of use. The remote sensor on the RS version
can either be left attached to the instrument for one-handed operation,
or separated for use in hard-to-reach areas of interest. The LN and LT
models can be used with or without disposable covers
Using the DermaTemp
The DermaTemp is equipped with an ON/OFF power button and a mode
selector switch, model specific. The mode selector switch allows you
to choose one of the three modes of operation, SCAN, MAX, or MIN.
The LT model is designed in a peak select mode, and automatically
selects and locks the highest reading when the ON/OFF button is
released.
ON/OFF:
To turn the instrument on, depress the red ON/OFF power push but-
ton. The single beep will audibly indicate that the instrument is on.
The display will momentarily read 8888,
an indication that the microprocessor is
performing a self-diagnostic check. Af-
ter the test, the unit will measure and dis-
play temperature in the selected operat-
ing mode for as long as the power button
is depressed.
To Lock Reading:
Release the red ON/OFF button to lock reading on display. The single
beep will audibly indicate that the display is locked. The DermaTemp
will hold the last reading on the display for 10 seconds before it auto-
matically turns off.
If you are using a DermaTemp 1001 LT, the highest temperature mea-
sured will be retained before automatic turn off.
To Restart:
Depress the button anytime to restart. It is not necessary to wait until
the display is clear. The DermaTemp automatically recalibrates each
time the button is depressed.
4