Filter
Top Products
Refer also to the MTPX Plus User’s Manual at www.extron.com.
Refer also to the MTPX Plus User’s Manual at www.extron.com.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
IP setup
Set IP address
EX2^
CI
}
Ipi
X2^]
Read IP address
E
CI
} X2^]
Set subnet mask
EX2^
CS
}
Ips
X2^]
Read subnet mask
E
CS
} X2^]
Set gateway IP address
EX2^
CG
}
Ipg
X2^]
Read gateway IP address
E
CG
} X2^]
Set DHCP on or off
EX2&
DH
}
Idh
X2&]
Read DHCP on/off status
E
DH
} X2&]
Set verbose mode
EX2*
CV
}
Vrb
X2*]
Read verbose mode
E
CV
} X2*]
Configure current port timeout
E
0*
X2(
TC
}
Pti0*
X2(]
Read current port timeout
E
0TC
} X2(]
Configure global IP port timeout
E
1*
X2(
TC
}
Pti1*
X2(]
Read global IP port timeout
E
1TC
} X2(]
N
X2^
= IP address nnn.nnn.nnn.nnn
X2&
= DHCP 0 =1 off, 1 = on
X2*
= Verbose mode 0 = clear/none (default for Telnet connection)
1 = verbose mode (default for RS-232/RS-422 connection)
2 = tagged responses for queries
3 = verbose mode and tagged for queries
X2(
= Port timeout interval 1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
Installing and Starting the Control Program
Another way to operate the switcher, to set the skew
adjustments, the level and peaking, and the output pre-peaking
(see "Optimizing the video", beginning on page 4-18), is via
the Windows
®
-based Matrix Switchers Control Program.
This program is contained on the Extron Software Products
DVD (included with the switcher). Run this program on a
PC connected to a serial port (
i
,
j
, and
m
on pages 2-5 and
2-6), Ethernet port (
k
), or USB port (
n
) on the switcher. The
program must be installed on a Windows-based computer and
cannot be run from the DVD.
N
For details on operating the program, refer to the
MTPX Plus User's Manual, chapter 5, “Matrix
Software”.
Installing the program
N
To run this program while your computer is connected
to an MTPX Plus 128 Configuration (USB) port, use
version 7.7 or newer of the Matrix Switchers Control
Program.
1. Insert the DVD into the drive. The Extron software DVD
window should appear automatically.
N
If the window does not self-open, run Launch.exe from the
DVD.
The Extron software DVD window appears.
2. Click the Software tab.
3. Scroll to the Matrix Switchers program and click
Install.
MTPX Plus Series • Remote Control and Optimizing the Video
Remote Control and Optimizing the Video, cont’d
4-14
MTPX Plus Series • Remote Control and Optimizing the Video
4-15