Filter
Top Products
P/2 DA4xi/6xi • User’s Guide
3
1. If rubber feet were installed on the bottom of the case,
remove them.
2.
Mount the unit on the rack shelf, as shown below,
using two 4-40 x 3/16 screws in opposite (diagonal)
corners to secure the case to the shelf.
Under-desk mounting
Under-desk mount the unit using the optional mounting kit
(part #70-077-01) as follows:
1.
If rubber feet were installed on the unit, remove them.
2. Attach the mounting brackets to the unit with the provided
machine screws, as shown below.
3. Hold the unit with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw head protrudes.
6.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7.
Slide the unit slightly forward or back, then tighten all four
screws to secure the unit in place.