Filter
Top Products
3
Product Category
NOTE: If surface mounting, route the wires through
alternate access points as shown at right.
ATTENTION: Use the appropriate mounting screws. The screw heads must
not protrude more than 0.27 inch (7 mm) above the screw holes in the
mounting plate (see the gure on the right). If the screw head protrudes too far
above the mounting plate surface, damage to the speaker may occur when
the speaker is attached.
Attaching a Secondary Support Cable
If a secondary support cable is being attached, attach the cable to the eye bolt, as shown
below. The cable end should be properly swaged.
Attaching the Speaker to the Mounting Plate
ATTENTION: By default, the SM 26 speaker is shipped unlocked. When mounting the speaker
to the mounting plate, be sure that the speaker is unlocked. Failure to place the speaker in
the unlocked position prior to mounting the speaker will result in damage to the speaker lock
mechanism (see Using the Security Key to Lock and Unlock the Speaker on the next
page).
NOTE: If a secondary attachment point is being used, see the “Attaching a Secondary Support
Cable” section above for installation details before proceeding further.
Position the rear mounting slot of the speaker above the catch tab of the mounting plate, then slide the
speaker down into the mounting plate until a click is heard indicating that the speaker is secured in place
(see gure at right). When properly seated, the speaker connections are automatically made.
Secondary
Attachment
Cable
Anchor this end to a
suitable secure point.
A
ttach cable here
and secur
e.
Catch Tab
0.47”
(12 mm)
0.27”
(7 mm)
Good
Bad
0° Mounting Plate
Alternate Access Point
Alternate Access Points
10° Mounting Adapter
33-0000-01 Rev. Ax1
IN
–
LOOP
–
IN
+
LOOP
+