CLEANING AUTO-START INFRARED SENSORS
PRODUCT MAINTENANCE
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note:twopaperdetectionsensorsarelocatedinthecenterofthepaperentry).
TO CLEAN THE SENSORS
Turnoffandunplug
shredder
Locate Auto-start
infared sensor
Usingcottonswab,wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
ENGLISH
Models 225Ci/225i
Allcross-cutshreddersrequireoilforpeakperformance.Ifnotoiled,amachinemayexperiencediminishedsheetcapacity,intrusive
noisewhenshreddingandcouldultimatelystoprunning.Toavoidtheseproblems,werecommendyouoilyourshreddereachtimeyou
empty your waste bin.
OILING SHREDDER
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
4
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
Press and hold forward
( ) 2-3 seconds
A. Door Open Indicator:Theshredderwillnotrunifthecabinetdoorisopen.Whenilluminated,closethe
door to resume shredding.
B. Bin Full Indicator:Whenilluminated,theshredderwastebinisfullandneedstobeemptied.UseFellowes
waste bag 36054.
C. Remove Paper Indicator: When illuminated, press reverse (
) and remove paper.
Reducepaperquantitytoanacceptableamountandrefeedintopaperentry.
D. SafeSense
®
Indicator:
I
f hands are too close to the paper entry, the SafeSense
®
indicator will illuminate
and the shredder will stop shredding. If SafeSense
®
is active for 3 seconds, the shredder will automatically
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning
Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
AUTO AUTO AUTO
2
3
AUTO AUTO AUTO
1
225C
225C
2 4
225C
1
A B C D