Filter
Top Products
4
Control Switch (E)
I AUTOMATIC
Turns on the auto-
matic-start sensor
and the green
Ready light.
O OFF
Turns off the auto-
matic-start sensor
and the green
Ready light.
R REVERSE
Runs shredder in
reverse mode.
Press and hold to
activate.
Troubleshooting Lights
Ready Light (F)
(Green)
Shredder is in
automatic start
mode.
Basket Ajar (H)
Waste basket
drawer is open.
Basket Full (H)
Waste basket is
full or paper has
collected under
cutting cylinders.
Paper Jam (I)
Shredder is
jammed (e.g.,
too much paper
fed at one time).
Overheat Light
(J)
Shredder has
overheated (e.g.
shredder has been
used for more
than 25 minutes).
For convenience and energy savings, your shredder is equipped with an
automatic-start
sensor
(K). This means that when the control switch (E) is in the automatic [I] position, the
shredder will start running when paper is fed into it. The shredder stops a few seconds
after the paper has passed through.
CAUTION:
The automatic-start sensor cannot tell the difference
between paper and other objects. This feature can also be a hazard.
Always turn off the shredder when it is not in use. Unplug the shredder
if it will not be used for an extended period.
To shred
• Press control switch (E) to automatic [I] position. Green ready light (F) should turn on.
PAPER
• Feed paper straight into entry (C), releasing when shredder begins shredding; see Product
Profile for limits on paper width, shreddable items, sheet capacity, etc.
• Shred no more than 25 minutes; shredding longer will cause shredder to turn itself off for
40 minutes to cool down.
• Press control switch to off [O] position after cutting has stopped.
Set-Up
• Pull waste basket drawer (A) completely out of cabinet.
• Put waste bag in basket (sample bags provided). Allow edges to overhang. Contact
Fellowes to order more bags. (Part #36053).
• Slide waste basket drawer (A) into cabinet. The shredder will not operate if drawer is not
pushed all the way into cabinet.
• Casters have been added for your convenience.
• Plug power cord into a convenient outlet.
Operation
Control Switches
E
F
J
H
I
3
Product Profile
This product is built to shred
paper, staples, small paper clips,
credit cards, CDs, and DVDs
(CDs and DVDs in designated slot).
It is not built to shred transparencies, adhesive labels, newspaper,
cardboard, large paper clips, or plastic (other than items noted
above). Attempting to shred items not intended for this shredder
may cause damage.
Confetti-cut
(C14)
Sheet capacity* 15 sheets
CD capacity 1
Paper shred size 5/32" x 1 1/2" (3.9 x 38 mm)
Maximum paper width 9" (230 mm)
Recommended daily capacity 100-200 shredding passes
Maximum running time 25 minutes
Automatic cool-down period 40 minutes
Voltage 120V-60Hz 6.0A
*Based on 20 lb., 8-1/2" x 11" paper with shredder operating at rated voltage; heavier paper, high humidity, or other than
rated voltage may reduce sheet capacity.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
• Check shredder for damage or defects; some paper particles in the basket are normal
due to product testing and does not indicate a defect.
• If the cord is damaged do not replace cord or use the machine. Return machine for a
replacement.
• Avoid touching exposed blades on underside of confetti-cut shredder head.
• Plug power cord in an outlet that can easily be reached. The plug is the primary electrical
disconnect.
• Make sure the electrical rating listed on the serial label (located inside, just below top of
shredder) matches the available electric power.
• Do not place shredder near or over a heat or water source.
While operating shredder
• Keep hands and hanging objects (jewelry, ties, loose clothing,
long hair, etc.) away from paper entry.
• Keep children and pets away from the shredder.
When not in use
• Always turn off and unplug shredder.
• Unplug before emptying basket.
• Do not open shredder head: Danger of electric shock.
Opening shredder head will void the warranty.
NOTE:
Do not use flammable synthetic oil, petroleum-based products
or aerosols of any kind on or near product at any time.