Filter
Top Products
Equipment Parts
1. Punching Handle
2. Sheet Supporter/Adjustable Coil Guide Selector
3. Adjustable Paper Margin Guide
4. Punching Area
5. Waste Paper Drawer
6. Binding Tray
7. Margin Depth Selector
8. Left Side Cover
9. Punching Handle Cover
Assembly
1. Attach the Punching Handle to the right side of the
machine by firmly pressing square hole of handle
onto square shaft. To operate correctly, the handle
should be positioned as illustrated above.
NOTE: If the handle is not positioned as illustrated
it will not punch. Once handle is fully attached
secure it by inserting the screw supplied.
2. Carefully attach the punching handle cover over
the punching handle.
3. To mount the Sheet Supporter/Adjustable Comb
Guide Selector, first be sure the two (2) phillips
screws are loose enough so the Supporter/Selector
slides easily into place. Mount Supporter/Selector
and secure by tightening screws.
Using the Punching
Machine
Adjusting the Punch
Holes should always be centered between the top and
bottom of paper edge. To center hole, set the
adjustable margin guide. For optimum results, first
use several “practice sheets” to set up margin guide
position.
Determining Coil Size
1. To select the appropriate coil for binding, insert
complete document under “leg” of adjustable coil
guide selector located on the bottom right side.
NOTE: Entire document should fit securely under
“leg” to determine true comb size.
2. Read the corresponding coil size from the center of
the adjustable coil guide selector.
3. Raise adjustable coil guide selector to release
entire document.
4.
OR
use chart below.
Choice of Coil
Sheets Coil Size
30 6 mm
45 7 mm
70 10 mm
85 13 mm
120 16 mm
140 18 mm
200 25 mm
Adjustment Margin Depth Selector
After choosing coil diameter, adjust the margin depth
selector according to the following guidelines. Align
number on guide with arrow on machine.
NOTE: The number on the dial should correspond to
the arrow on the cover.
Position Coil Diameter
1 6-14 mm
2 17-22 mm
3 25 mm
A
B
C
®
9
5
1
4
8
3
7
6
2