Filter
Top Products
4
Designed for maximum flexibility, the wired remote
control section is the "brain" of the PowerStage 100.
Whether hand held or mounted to a mic stand, the
wired remote control unit governs all volume levels,
frequency shaping and features a 1/4 inch
headphone jack for personal monitoring.
Constructed from rugged 18 gauge electro-
galvanized steel and secured in place via ball stud
and Tinnerman clips, the remote unit handles the
most demanding, day to day setup and performance
situations.
A. MIC 1 - The Mic 1 volume
control. Rotating the knob
clockwise increases volume.
Because the Mic 1 input and
the Mic 1 output connections
are "daisy chained", adjusting
the volume control will not
affect the Mic 1 output signal to
the main mixing console.
B. MIC 2 / INST - The Mic 2 /
Inst volume control. Rotating
the knob clockwise increases
volume. Any adjustments to
this control will affect both the
Mic 2 and the Inst output
volume.
C. LINE - The Aux Line / Stereo
Line volume control. Rotating
the knob clockwise increases
volume. Any adjustments to
this control will affect both the
Aux Line and the Stereo Line
volume.
D. MASTER LEVEL - Adjusts
the overall volume level of the
PowerStage 100. Again,
rotating the knob clockwise increases volume. If the
optional PowerStage Xpander 100 is connected to
the system, the master level also controls the output
volume for the other unit.
E. LOW CUT - Designed to attenuate low frequency
noise or "stage rumble", the LOW CUT knob is a
variable corner (shelving) frequency control. By
slowly rotating the knob, any undesirable low
frequency noise, such as rumbling of a rocking
microphone stand, can be diminished.
F. LOW NOTCH -
Designed to
attenuate
feedback or
other
bothersome
hums, the LOW
NOTCH
control is a
constant Q,
variable center
frequency filter.
The control
attenuates frequencies between 200Hz and 2kHz.
By slowly rotating the knob to locate the feedback
frequency, it can be diminished.
G. HIGH NOTCH - Designed to attenuate feedback
or other bothersome hums, the HIGH NOTCH control is
a constant Q, variable center frequency filter. The
control attenuates frequencies between 600Hz and
6kHz. By slowly rotating the knob to locate the
feedback frequency, it can be diminished.
H. LEVEL - Adjusts
the volume level of
the headphone
output. Caution:
Prolonged listening
at high volume levels
may be hazardous
to your hearing and
could possibly cause
hearing damage.
- A 1/4 inch
stereo output jack for use with headphones.
J. ENHANCE - Pressing this button in provides an
increase in the bass and treble response of the
PowerStage 100.
CONTROL PANEL FUNCTIONS
A
B
D
C
G
E
F
J
I
H
I.