Filter
Top Products
19
16
The preparation display will disappear
after 30 seconds.
(See page 46 for Lamp control status.)
Lamp control status
Tu r ning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red.
Open the slide shutter by sliding the slide shutter
lever. (see page 53)
Press the ON/STAND-BY button on the top control or
the remote control. The POWER indicator lights green
and the cooling fans start to operate. The preparation
display appears on the screen and the count down
starts.
2
3
1
4
After the countdown, the input source that was
selected the last time and the lamp control status icon
(see page 46) appear on the screen.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed below.
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
What is PIN code?
PIN (Personal Identification Number) code is a security code
that allows the person who knows it to operate the projector.
Setting a PIN code prevents unauthorized use of the
projector.
A PIN code consists of a four-digit number. Refer to the PIN
code lock function in the Setting Menu on page 48 for locking
operation of the projector with your PIN code.
Enter a PIN code
Use the Point ed buttons to enter a number. Press the Point
8 button to fix the number and move the red frame pointer to
the next box. The number changes to “✳.” If you fixed an
incorrect number, use the Point 7 button to move the pointer
to the number you want to correct, and then enter the correct
number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
“Set.” Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect PIN code, “PIN code” and the
number (✳✳✳✳) will turn red for a moment. Enter the correct
PIN code all over again.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take a special care in setting a
new PIN code; write down the number in a
column on page 65 of this manual and keep it at
hand. Should the PIN code be missing or
forgotten, consult your dealer or service center.
Selected Input Source and Lamp Control
After the OK icon disappears,
you can operate the projector.
PIN Code Input Dialog Box
✔Notes:
•When the Logo select function is set to “Off,”
the logo will not be shown on the screen (p.43).
•When the “Countdown off” or “Off” is selected
in the Display function, the countdown will not
be shown on the screen (p.42).
•During the countdown period, all operations are
invalid.
•If the correct PIN code number is not entered
within three minutes after the PIN code dialog
box appeared, the projector will be turned off
automatically.
•The “1234” is set as the initial PIN code at the
factory.
•When the Input Search function is set to “On2”,
the input signal will be searched automatically
(p.45)
✔Note:
•The Filter warning and Lamp replacement icons
may appear on the screen depending on the
usage state of the projector.
Basic Operation