Filter
Top Products
20
The message will disappear after 4 seconds.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE
YOU TURN THE PROJECTOR ON, WAIT AT
LEAST FIVE MINUTES BEFORE TURNING IT OFF.
Tu r ning Off the Projector
Press the ON/STAND-BY button on the top control or on
the remote control, and “Power off?” appears on the
screen.
Press the ON/STAND-BY button again to turn off the
projector. The POWER indicator starts to blink red, and
the cooling fans keep running. (You can select the level
of fans’ quietness and speed. See "Fan" on page 49.)
At this time, you can unplug the AC power cord even if
the fans are still running.
1
2
3
When the projector has cooled down enough, the
POWER indicator stops blinking and you can turn on
the projector. After it is cooled down completely,
unplug the AC power cord.
✔Notes:
•When the On start function is set to “On,” the projector will be
turned on automatically by connecting the AC power cord to an AC
outlet (p.46).
•Do not operate the projector continuously without rest. Continuous
use may result in shortening the lamp life. Turn off the projector
and let stand for about an hour in every 24 hours.
•The running speed of cooling fans is changed according to the
temperature inside the projector.
•Do not put the projector in a case before the projector is cooled
enough.
•If the WARNINGindicator blinks or lights red, see “Warning
Indicators” on page 51.
•While the POWER indicator is blinking, the lamp is being cooled
down and the projector cannot be turned on. Wait until the
POWER indicator stops blinking to turn on the projector again.
Basic Operation