Filter
Top Products
ADJUST THE OSD MENU ITEM
Displaying characters such as for setting
location on the monitor screen (Refer to
“CHARACTERS TABLE”.)
Note: If there is no signal being input from the input
terminals selected (A, B or Y/C) at the rear of
the monitor, the title cannot be set for those
terminals.
1 Select “9. TITLE ON” and then press the
ENTER button.
2 To display “ABCD” on the CH B monitor as an
example:
A maximum of eight characters can be displayed
on the screen.
Note: The setting screen will disappear after
approximately 13 seconds of no activity.
1. Use the cursor (l) button to select “CH B”.
2. Press the ENTER button, and then use the cursor l
(j) button to select “A”.
3. Press the ENTER button, and then use the cursor l
(j) button to select “B”.
4. Press the ENTER button, and then use the cursor l
(j) button to select “C”.
5. Press the ENTER button, and then use the cursor l
(j) button to select “D”.
6. Press the OSD button.
The cursor will move to the next monitor display.
The settings for the CH A and CH Y/C monitors can
be carried out by the same procedure as described
above.
3 Use the cursor l (j) button to select “TITLE
ON”, and then press the ENTER button.
The text that has been set for that monitor screen
will then be displayed.3 14 2l52.113 822 23226 cRc98744 249.924 825.202 249.924 8î879 8230.628î879 8230.h3 8 249ue019 826.l52.11259.39.6.l52.86 2.11at69 r260.633 82162.1903 82re4e5yed.3 yb7789 250c99 826.149 c7c99 82639.6.l52..t.eo 9 82639.6.26.149 c7c9a39 82639.660.633 23.991 .3GS2 5660.6360.6333poo 9 82639.60260.436 820hc7c9826.58 25052.868 3 82162.1903 82re4e5yed.