Filter
Top Products
2
The Model CD-1A is designed exclusively for the VF160 digital multitracker.
By installing the CD-1A to the VF160, you can;
* save or load your song data to or from a CD-R/CD-RW disc,
* make your original audio CD using materials recorded on the VF160, or
* load song data from an audio CD.
This manual describes how to install the CD-1A in the VF160. See the VF160 operation
manual for details about how to save/load song data or how to make an audio CD.
Introduction
<Notes on handling of discs>
This product includes the
following in the package.
If you cannot find all of the
contents listed above,
please contact your dealer
or local Fostex sales office.
* a blank panel
* two screws for mounting the drive
* a CD-RW drive unit
• When handling a disc, be careful not to dirty
or scratch the surface of the disc.
We recommend that you hold the disc with
your finger on the disc edge and center hole.
• Do not stick any paper, etc. on the label side.
Also do not scratch the label side, which may
cause problems during playback or
recording. Use only a felt pen or equivalent
for writing any memo on the label side. Using
a ball-point pen, pencil, etc. that has a hard
tip may damage a disc.
• Never use a warped or chipped disc, which
may damage the CD-RW drive.
<Usable discs>
With the CD-1A, you can use discs of fol-
lowing types.
<CD-R discs>
Can be used for saving or load-
ing song data, as well as mak-
ing an audio CD.
Note that you can record data
to a CD-R disc only once. You
cannot record data to a disc
which has been recorded be-
fore.
<CD-RW discs>
Can be used for saving or
loading song data, as well as
making an audio CD.
You can record or erase data
to a CD-R disc as many times
as wish.
<Audio CD discs>
As these are read-only discs,
you only can use them for
loading track data to the
VF160.
See the VF160 operation manual for details
about how to save/load song data or how to
make an audio CD.
<Check the contents in the package>