Filter
Top Products
Cushion
56
How to stack the PD-6 and EX12 together
1) Remove the blank panel at the bottom of the
PD-6.
2) Replace the two screws for fixing the rubber
feet at the bottom of the PD-6 with the screws
supplied with the EX12.
<Note>:
Never forget to replace the screws
for fixing the rubber feet. Otherwise, the PD-
6 may malfunction or generate a noise be-
cause of imperfect grounding.
3) Remove the two screws for fixing the cover at
the top of the PD-6, and open the cover.
<Note>:
The removed screws are used later
for fixing the cushion. Be sure not to lose
them.
4) Fix the supplied cushion using the fixing screws
which are removed in the previous step.
6) Put the PD-6 on the EX12 and plug the
connector of the cable to the PD-6, as shown
below. Make sure to plug the connector in the
correct direction.
5) Pull out the connection cable from inside the
EX12.